Heater, Aqua Hot 125 Series Hydronic, Diesel Kit

The Aqua-Hot 125 Hydronic heating and hot water systems are high-performance solutions that are tailored to meet the needs of high-altitude use. The system is characterized by the following features:

• High Altitude Ready: It operates efficiently at altitudes up to 16,000 ft. and automatically adjusts the fuel-to-O2 ratio to optimize burner flame and provide consistent, reliable heat and hot water without the need for additional kits or add-ons.
• No Additional Maintenance: Unlike other systems, the 125 will not soot up or require additional maintenance due to high altitude use.
• Great for Off-Grid: It uses the van’s fuel and doesn’t require any supplemental fuel.
• Heat Where You Need It: Compact, quiet heat exchangers can be placed throughout the interior where heat is needed, eliminating hot spots and cold spots.
• Continuous Hot Water: It provides 110-120ºF at .8 GPM for the kitchen and shower.
• Quiet: The combustion unit is outside the van and has its own muffler, while low-decibel fans provide heat inside.
• Night Mode: Provides ample heat with further noise reduction.
• Dual Power Source: The 125 can also provide heat and hot water using 120v shore power.
• LCD Controller: Up to 3 independently controlled zones, plus test and diagnostic read-out (easy to use).
• All-in-One or Modular Systems: Available in all-in-one systems as well as modular systems and also available in both gas and diesel versions.
• Nationwide Service Network: The 125 is supported by over 300 service centers throughout North America.

The 125 is designed to provide a comprehensive heating and hot water solution that is reliable, efficient, and easy to use.

**Requires installation by an Aqua-hot approved facility. DIY installations are subject to have their warranty voided.

Share

Kit includes,  [AHE-125-DN2] Heater, Aqua Hot 125 Series Hydronic, Diesel,  3x [EXE-103-0EX] Exchanger, Heat Cozy III, 3x  [ELX-THM-309] Thermistor- White,  [ple-000-201] 8 Ft. Section of 5/8 in. Safety Stripe Rubber Hose, 20x  [plx-ctb-270] Clamp, Hose Constant Tension Hose Clamp 15/16 in. for ¾” Hose,  10x  [plx-284-74v] Hose, Molded, Elbow 90*, 3/4 X 3/4 X 10 long, AH/HH,  4x  [PLX-A51-106] Bend Support, 5/8, Polytube, 8x  [PLX-000-820] Fitting, Elbow 3/4 in Black Nylon,  [ELE-125-200] Harness, 125, Coach Side